![]() ![]() ![]() Do not over twist thus causing the wire to pop-out. Using your fence pliers, gently twist the wire at each barbwire arm to get the wire into the angled slot.Cut your barbwire and attach to the end band.When stretching the wire, there will remain a considerable amount of sag in the wire when stretched from terminal post to terminal post. ![]() A common mistake in stretching barbwire is stretching it too tight.Keeping constant pressure on the cable, crank the come-a-long until the barbwire is taut.Place the fixed end of the come-a-long into the eye of the wire dog.Wrap the cable end of your come-a-long the terminal post above the end band.Place your wire dog approximately ten feet from the terminal post. Pull the barbwire taut by hand along the fence line.At the other end of the stretch, pull the spool past the terminal post and estimate how much wire you will need to complete the stretch.It is important that you don’t leave loose loops around the wire because when tension is applied the wire may come unraveled. With tightly wound loops at least four times. With your pliers, bend a six inch section of barbwire around the nut and bolt located in the end band.Either way, slowly pull the barbwire along the inside of the fence line to the other terminal post.Or you may walk along the fence line allowing the barbwire to spool-out as you walk. You may use a stationary barbwire spooler to spin-out the barbwire as you pull the barbwire along the fence line. Locate the spool at the far end of the stretch.Evenly spaced and with the ears pointed down the fence line, tighten the bands. Install three end bands on each terminal post.If this is not clearly shown on your plans, specifications or proposal, obtain this information before preceeding with installing the arms. Having already installed the barbwire arms when stretching the fence, you will have already determined if the barbwire is to go in, out or vertical.Be sure that you are wearing safety glasses and gloves, keeping control of the materials at all times. Consequently, it has a tremendous capacity to cut and harm. Barbwire has either two point or four point barbs every 4” or 5” respectively. Again, it will want to unravel and tangle so firmly keep it in your grasp. Like tension wire, be careful when cutting loose the barbwire roll. When the wire is stretched it causes the twists to bind, thus creating a spring like action. The spring in barbwire comes from the twisting of two 12 ½ gauge wires around each other, completing five twist per foot. Unlike tension wire, barbwire is manufactured from mild steel materials. come-a-longs, pliers, bolt cutters, chop saw or hand saw, wire rake for the appropriate height wire, speed wrench with ½” socket, barb wire dog, T-bar, and hammer. Objective: By mastering this lesson, you will be able to barbwire installation.Įquipment: 2ea. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |